DSDT Compile and Trackpad help needed

[rumeny]

Hello, yesterday i install Catalina 10.15.1 using OpenCore it was success after few tries, i got the keyboard working, but i didn't manage to get trackpad working its Elan 0501 so i injected Voodoo* kexts properly and when i open System DSDT i can see there TPDE which is for my trackpad but i am not able to see it IOReg how i am supposed to fix that and attach the TPDE so i can see it in IOReg.

Also i got issues compiling the DSDT i got the following error: syntax error, unexpected PARSEOP_ARG1, how i am able to fix that.

I really really need to get the trackpad. It was working great with Olarila image and the kext's i was using i applied them to OpenCore as well, but i can't get the trackpad to work

Acer Aspire E5-575-53vg

CPU: Intel i5-6200U

GPU: Intel HD 520

WiFi/BT: 1820A working great

TP: Elan 0501

[onemanosx]

[ref]rumeny[/ref], You did not upload your ACPI origin folder

[rumeny]

I'm not able to compile or save the system dsdt via MaciASL it says syntax error, unexpected PARSEOP_ARG1

[onemanosx]

I'm not able to compile or save the system dsdt via MaciASL it says syntax error, unexpected PARSEOP_ARG1

Because you did not upload DSDT or ACPI tables from origin folder as requested, I can only assume the following:

1. If the error to compile is before your edit, then make sure you are using the most current MAcIASL from Acidanthera github. Or, you need to edit the DSDT to remove the error.

2. If error to compile only appears after your edit, then your patching is wrong.

[rumeny]

I am using the most current MaciASL from Acidanthera GitHub repo.

The error pops when I am compiling without patching, and I just run the Runme.App to so you can take a look, otherwise I cannot save the System DSDT. I am using OpenCore

[onemanosx]

I am using the most current MaciASL from Acidanthera GitHub repo.

The error pops when I am compiling without patching, and I just run the Runme.App to so you can take a look, otherwise I cannot save the System DSDT. I am using OpenCore

Yes, do upload your ACPI tables from origin folder

[rumeny]

Here you are

ACPI.zip

[onemanosx]

[ref]rumeny[/ref], Have fun.

DSDT.dsl.zip

[rumeny]

This fixes errors only right?

Thank you, much appreciated!

[onemanosx]

This fixes errors only right?

Yes, its clean.

[rumeny]

Thanks a lot, I applied Windows 10 patch and GPIO Controller Enable successfully, but ried to apply I2C Controllers i got the syntax error, unexpected PARSEOP_IF, expecting $end and premature End-Of-File

[onemanosx]

but ried to apply I2C Controllers

If your cpu is skylake or above, I2C Controllers patch is not required.

[MaLd0n]

[ref]rumeny[/ref], full patched DSDT.aml.zip

remove ssdts, use ec0 to ec rename patch