Blinking cursor after cloning HDD to SSD

[Pentothal.Z]

Ok people, finally I managed to get a Crucial mx500 ssd so I cloned my old hdd on the new ssd using CCC.

Then I installed clover 5058 on the new ssd and copied the EFI folder from the old hdd.

The problem is that when I try to boot from the ssd I just get a blinking cursor.

If I boot the system from my old hdd the system boots up but I would like to erase the old hdd and use it only as storage.

Anyone able to help?

Thanks in advance

Send me Franks-iMac.zip

[MaLd0n]

[ref]Pentothal.Z[/ref], install clover into ESP with boot0ss, work for uefi and legacy mode

[Pentothal.Z]

MaLd0n Thanks for your help! How do I enable trim?

Clover or terminal

Thanks again MaLd0n

[MaLd0n]

[ref]Pentothal.Z[/ref], clover or terminal

[Pentothal.Z]

Thanks MaLd0n

I did some disk benchmarks.......a bit disappointed I thought it would have been faster. Any Idea why? TRIM has been enabled via terminal.

I get 247.8 MB/s write and 266.2 MB/s read......any idea why it's so slow?

[MaLd0n]

[ref]Pentothal.Z[/ref], check if ur mobo have a sata 2 port, use ever in sata 3 port

[Pentothal.Z]

It looks like I have sata 2

Vendor: Intel

Product: 6 Series Chipset

Link Speed: 3 Gigabit

Negotiated Link Speed: 3 Gigabit

Physical Interconnect: SATA

Description: AHCI Version 1.30 Supported

[MaLd0n]

[ref]Pentothal.Z[/ref], ye, sata 2(3 Gigabit)

sata 3 is 6 Gigabit